Industrial drawing and geometry; an introduction to various branches of technical drawing (1911)
Spooner, Henry John, 1856- · London, New York [etc.] Longmans, Green, and co. · leaf 160
n that the proportional parts in terms of the unit used (d + i) in designing it are given, but it has been also dimensioned for a 3drawing exercise, and you only need pay attention to the actual dimensions given. - The taper is always made on the coupling or boss, which is fitted to the shaft,… … Pig. 473, 474.—End elevation and elevation of a gun-metal tail guide for valve rod. shaft as a 142 INDUSTRIAL DRAWING AND GEOMETRY are placed to read borizontally in the spaces left for them between the diinensLoa lines, and all vertical dimensions read frombottom to top of drawing when looking…
Mechanical drawing · Geometrical drawing
Internet Archive · Library of Congress · Public Domain Mark 1.0. Free to use for anything.
