American machinists' handbook and dictionary of shop terms : a reference book of machine shop and drawing room data, methods and definitions (1914)
Colvin, Fred H. (Fred Herbert), 1867-1965, Stanley, Frank A. (Frank Arthur), b. 1874 · New York : McGraw-Hill book company ; London : Hill · leaf 175
acticallyall requirements. They are made in sizes of i inch, i^ inches, i^ 146 MILLING AND MILLING CUTTERS inches and 2 inches in diameter, the smallest with four, and thelargest with eight teeth. In order to preserve the strength of theteeth it is necessary to mill the back of the teeth of the… … Spiral Shell Cutters clamped to the table of the milling machine and the knee was fedupward. The same cutter would remove from the end of the castinga section i| inches wide and i| inches deep. Under the latter con-ditions, the chips would free themselves from the cutter and thesechips were rolled…
Machine-shop practice
Internet Archive · UMass Dartmouth, Claire T. Carney Library · Public Domain Mark 1.0. Free to use for anything.
