The blacksmith's guide : valuable instructions on forging, welding, hardening, tempering, casehardening, annealing, coloring, brazing, and general blacksmithing (1907)
Sallows, J. F. (James Francis), 1865- · Brattleboro, Vt. : The Technical Press · leaf 40
MACHINE FORGING' 27 and bend as shown at B, which will open up the out¬ side corner, as indicated at x, and give an opportunity to weld in a piece for the purpose of building up a good, solid square corner. To do this, take a bar C of … Fig.43 Forging a Square Corner. smaller square stock, heat and cut one end nearly off. Now even up the sides of the opening in the corner of B, take a welding heat on the end of C, and weld the piece cut off from the smaller bar into the open corner of B. The corner can then be hammered out square…
Blacksmithing
Internet Archive · Getty Research Institute · Public domain (published before 1931). Free to use for anything.
![An illustration from [Volume I.]](https://img.insideoutlibrary.com/img/200/erara-31314765-446-1.webp)
